Custom Cables RCA to 1/4" TS Mono Audio Cable Made from Canare LV-61S & Neutrik Connectors

Custom Canare LV-61S RCA to 1/4" TS Mono Audio Cable

Connect an RCA audio connection to a 1/4" TS connection with a cable built to fit your setup. Made to order by Performance Audio using Canare LV-61S coaxial cable and genuine Neutrik connectors, this single-channel assembly keeps your cable run tailored to the distance between your equipment.

One Cable, One Unbalanced Audio Channel

This cable carries one channel of unbalanced analog audio between compatible RCA and 1/4" TS connections. It can be used in either direction when the source output and destination input are compatible. For separate left and right stereo connections, use two cables.

Check your equipment's connection type and signal level before ordering. Matching plugs do not make every output and input compatible: this cable does not balance a signal, change its level, or provide electrical isolation. It is not a stereo TRS cable or a speaker cable for connecting a power amplifier to a passive speaker.

Built Around Canare LV-61S

• Canare LV-61S coaxial cable: this assembly uses 75-ohm coaxial video cable as its wire, terminated for an RCA-to-TS analog audio connection.
• Genuine Neutrik connectors: RCA and 1/4" TS connections for your selected configuration.
• Black cable: a straightforward finish for studio, rack, and equipment connections.
• Custom labeling and finishing options: identify the signal path and organize your setup.
• Made to order with a lifetime warranty: a custom-built assembly backed by Performance Audio.

The bulk wire's 75-ohm specification does not make this finished RCA-to-TS assembly a specified digital-audio or video interconnect. Choose a purpose-built cable with the correct connectors for those applications.

Plan the Run Before You Order

Measure along the actual cable route, allowing enough slack for strain relief and access to your equipment without leaving unnecessary coils. Check clearance behind recessed connections, crowded patch panels, and nearby controls when selecting connector configurations. Keep unbalanced runs practical for your setup and route them away from power supplies and AC cables where possible.

Connect an output to an appropriate input, not two outputs together. Once installed, check both ends for a secure fit and test the signal path at a low listening level before normal use.

Need a Different Configuration?

If you are unsure about connector fit, signal levels, cable length, or a wiring requirement, contact Performance Audio's custom cable specialists with your equipment models. We can help you plan a cable for the connection you need, including configurations you cannot build online.