Crown CDi DriveCore 2|600BL 2-Channel Power Amplifier with BLU Link (600W)

CDi DriveCore Series Two-Channel Power Amplifier, Analog + BLU Link Input, 600W Per Output Channel

The CDi DriveCore Series is an evolution in amplification, providing an impressive mix of high-performance; rich feature set, and competitive cost. Using technology derived from our flagship Installed Sound amplifier (Crown DriveCore Install series), the CDi DriveCore 2|600BL offers streamlined functionality to work in almost any medium sized installation such as cinema, houses of worship, bars, lounges, and more. Designed for ease-of-use in a variety of applications, the 2|600BL is a 2-channel amp that includes network control/monitoring, high-level DSP, front-panel interface, and support for driving up to 100Vrms speaker loads without requiring a transformer. The 2|600BL also comes with BLU link, adding the ability to send and receive channels over HARMAN's digital audio BUS. The entire CDi DriveCore line comes pre-loaded with JBL speaker tunings to help make installations quicker and easier.

Features:

• DriveCore Technology - Crown's proprietary DriveCore technology eliminates hundreds of components within each amplifier, reducing the variability of component values, increasing reliability, resulting in incredible audio fidelity from an efficient design.
• Network Control and Monitoring - Through Harman's HiQnet Audio Architect software, the CDi DriveCore can be controlled, configured, and monitored through standard TCP/IQ network.
• DSP - On-board Digital Signal Processor in each amplifier allows for custom configuration
  Input Router
  Input Delay - Up to 1000ms
  Input Parametric EQ - 8 band
  Crossover
  Output Parametric EQ - 8 band
  Output Delay - Up to 100ms
  LevelMAX Limiter
• BLU link (BL models only) - Both receive and send channels over HARMAN's 256 channel, fault-tolerant audio BUS, BLU link
• Direct Drive 70/100Vrms Output - Each output channel is capable of provide either 70V or 100V for high impedance applications.
• Front-Panel Interface - Completely configure the amplifier using an intuitive front-panel interface.
• GPIO/AUX Port - Recall presets, mute channels, monitor faults, power on/off the amplifier, and more through a combined GPIO/AUX Port.

Specifications:

• BLU link: Yes
• Channels: 2
• Sensitivity (for full rated power at 8 ohms): 0.7V RMS
• Rated Power Output (per channel @ 4 ohms): 600W
• Analog Input Signal to Noise Ratio (ref. rated power, 100V, 20Hz - 20kHz) at 8 ohms): > 104dB
• THD (full rated power, 20 Hz - 20 kHz): 0.35%
• Damping Factor (20 Hz to 100 Hz): > 1000
• Frequency Response (8Ω, 20 Hz - 20 kHz): +/-0.5dB
• Crosstalk (below rated power) 20 Hz to 1 kHz: > 80dB
• Input Impedance (nominally balanced, nominally unbalanced): 20 kΩ balanced, 10 kΩ unblanced
• Dimensions (inches) (W x H x D) (depth not including 1.3 inch front panel protrusion): 19 x 3.5 x 12.25
• Weight: 14.56 lbs (6.6 kg)
• Power Supply Connector: Standard IEC type 320 inlet for detachable connector 100 - 240V~

Includes:

• Crown CDi DriveCore 2|600BL 2-Channel Power Amplifier with BLU Link (600W)
• 2 x Terminal Block
• Power Cord
• Limited 3-Year Warranty