DPA d:dicate 4011ES Cardioid Microphone with Side Cable

d:dicate 4011E Cardioid Microphone with Side Exit Active Cable

d:dicate 4011E Cardioid Microphone, Active Cable

4011ER Cardioid Microphone, Rear Cable
4011ES Cardioid Microphone, Side Cable

Ideal for unobtrusive spot miking, such as hanging or table use, the 4011E is an ultra-compact cardioid microphone from the modular DPA d:dicate Recording Microphones series.

With a length of only 3,5 cm, the low-key appearance of the 4011E is followed by the SM4000-C suspension mount, which is included in the package. This allows the 4011E to be hung from the ceiling and create precise and repeatable positions and angles when spot miking orchestra sections or ambience atmospheres.

Capable of handling high SPLs without distortion, the 4011E is perfectly tailored for close-miking applications, minimizing bleed from other instruments. Therefore chosen for close-miking of instruments like acoustic guitar, drums or grand piano, the 4011E with its accessories can be placed for instance in the piano frame.

At any time and with no tools necessary it is possible to transform the basic 4011E microphone into a new configuration by combining it with another DPA microphone capsule or preamp.

Features:

• Ultra-compact spot or hanging mic
• Very linear frequency and phase response
• Huge dynamic range
• Low-key appearance

Specifications:

• Directional pattern: Cardioid
• Principle of operation: Pressure gradient
• Cartridge type: Pre-polarized condenser
• Frequency range: 20 Hz - 20 kHz
• Frequency range, ± 2 dB, at 30 cm: 40 Hz - 20 kHz
• Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
• Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
• Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB
• S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 76 dB(A)
• Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
• Dynamic range: Typ. 121 dB
• Max. SPL, peak before clipping: 144 dB
• Output impedance: 100 Ω
• Minimum load impedance: 2 kΩ
• Cable drive capability: 100 m (328 ft)
• Output balance principle: Impedance balancing
• Common Mode Rejection Ratio (CMRR): > 40 dB
• Power supply (for full specifications): 48 V Phantom power (± 4 V)
• Current consumption: 3.5 mA
• Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
• Color: Matte black
• Weight: 109 g (3.8 oz)
• Microphone diameter: 19 mm (0.75 in)
• Capsule diameter: 19 mm (0.75 in)
• Microphone length: 35 mm (1.38 in)
• Output voltage, RMS: 2.2 V
• Polarity: +V at pin 2 for positive sound pressure
• Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
• Relative Humidity (RH): Up to 90%
• Matching tolerance: ± 1 dB
• Phase deviation for kit: < 10°