Skip to content

FREE USA Shipping $49+!

Sewell Silverback Pro Nickel Plated Solder & Screw Banana Plugs (1 Red & 1 Black)

Sewell SKU: SEW SILVERBACKPROBAN
MPN: SW-33209

Price:
Sale price$8.00
Stock:
28 In Stock & Ready to Ship

Key Features

  • Professional Solder + Screw Connection
  • Nickel Plated Brass Connector
  • Aluminum Outer Sleeve
  • Non-Conductive Black Coating
  • Up to 10 AWG Wire
  • 1 Red & 1 Black

Description

Sewell Silverback Pro nickel-plated solder-and-screw banana plugs

Sewell Silverback Pro banana plugs provide plug-in speaker-wire connections for compatible banana sockets on speakers, amplifiers and receivers. Nickel-plated brass tips are designed to resist wear and corrosion, while the solder-plus-screw termination offers a more permanent wire connection for home and suitable commercial audio setups. Red and black identification helps keep speaker polarity consistent.

Includes two individual plugs: one red and one black. This pair terminates the positive and negative conductors at one end of a two-conductor speaker cable. For banana plugs at both ends of that cable, use two pairs, four plugs total. Speaker wire is selected separately.

Solder plus screw lock, not just a screw-on plug

The manufacturer's description specifies soldering plus the screw lock for the full-strength connection. Screw-only use is described for temporary, low-tension connections. Choose these plugs when you are prepared to solder the wire termination rather than assuming the screw alone provides the same retention.

Use an appropriate soldering setup and flux suitable for electrical connections, following the manufacturer's assembly instructions. A screwdriver is mentioned for separate six- and twelve-packs; this two-plug listing does not establish that a screwdriver is included. Have the required assembly tools available.

Wire fit and equipment compatibility

The listed maximum wire size is 10 AWG. Check conductor fit, cable-entry clearance and the manufacturer's termination requirements before assembly. Wire insulation thickness and conductor construction can affect fit. Your equipment must have compatible banana sockets; these plugs do not replace spade terminals or locking speaker connectors.

The aluminum housing has a listed non-conductive black coating that helps reduce accidental contact between housings. It is not a guarantee against shorts: keep bare wire, contact tips and damaged coating away from adjacent terminals and other conductive surfaces.

Assembly and connection guidance

  1. Switch off the amplifier or receiver before changing speaker connections.
  2. Prepare the plug and speaker wire according to the manufacturer's instructions, keeping strands together and exposing only the conductor needed for termination.
  3. Complete the specified solder-and-screw connection, protecting the housing, coating and wire insulation from excessive heat. Allow the joint to cool before final handling.
  4. Inspect for stray strands, solder bridges and exposed conductor that could touch another terminal. Check wire retention before connection.
  5. Connect to compatible banana sockets, using red and black consistently with the equipment's positive and negative terminals. Leave the cable supported so it does not pull on the plug.

Features and specifications

  • Model: Sewell Silverback Pro.
  • Contents: one red plug and one black plug.
  • Contact tip: nickel-plated brass.
  • Housing: aluminum with a listed non-conductive black coating.
  • Termination: solder plus screw lock for the manufacturer's full-strength connection.
  • Screw-only use: temporary, low-tension connections as described by the manufacturer.
  • Maximum listed wire size: 10 AWG.

Nickel plating provides a wear- and corrosion-resistant contact finish; it does not guarantee improved sound quality or suitability for every environment. Confirm connector fit and installation requirements for your equipment.

Details
  • Manufacturer:  Sewell
  • MPN: SW-33209
  • Model Number: Silverback Pro Banana Plugs

You may also like

Recently viewed