Custom Cables RCA to 3.5mm (1/8") TS Mono Audio Cable Made from Mogami W2319 & Neutrik Connectors

Custom Mogami W2319 RCA to 3.5mm TS Mono Audio Cable

Connect an RCA audio connection to a 3.5mm (1/8") TS mono connection with a cable built to fit your setup. Made to order by Performance Audio using Mogami W2319 instrument cable and genuine Neutrik connectors, this single-channel assembly lets you plan the run around your equipment rather than work around an off-the-shelf length.

One Cable, One Unbalanced Audio Channel

This cable carries one channel of unbalanced analog audio between compatible RCA and 3.5mm TS connections. It can be used in either direction when the source output and destination input are compatible.

The 3.5mm end is TS mono, not TRS stereo or TRRS headset. This is not a stereo-to-mono summing cable or a left/right breakout. Do not assume it will work with a stereo headphone socket, a phone headset jack, or a powered microphone input simply because the plug fits. Check the socket's wiring, signal level, and any plug-in-power requirements before connecting.

This passive cable does not change signal levels, create a balanced connection, or provide electrical isolation. It is not a digital-audio cable or a speaker cable for connecting a power amplifier to a passive speaker.

Built Around Mogami W2319

• Mogami W2319 instrument cable: the specified wire for this custom RCA-to-3.5mm TS assembly.
• Genuine Neutrik connectors: RCA and 3.5mm (1/8") TS mono connections for your selected configuration.
• Black cable: a straightforward finish for your equipment setup.
• Custom labeling and finishing options: identify the signal path and organize your cable run.
• Custom made to order with a lifetime warranty: a Performance Audio assembly built for your specified requirements.

Plan the Run Before You Order

Measure along the actual cable route, allowing slack for strain relief and equipment access without unnecessary excess. Check clearance around recessed 3.5mm sockets, device cases, nearby controls, and crowded rear panels. Support the cable so its weight does not pull on a small equipment socket, avoid sharp bends, and route unbalanced runs away from power supplies and AC cables where possible.

Connect an output to an appropriate input, not two outputs together. Once installed, check both ends for a secure fit and test the signal path at a low listening level before normal use.

Need a Different Configuration?

If you need stereo audio, a left/right breakout, or a device-specific connection, contact Performance Audio's custom cable specialists with your equipment models and the sockets you intend to use. We can help you plan the appropriate wiring and cable configuration, including options you cannot build online.