Custom Cables RCA to 1/4" TS Mono Audio Cable Made from Canare GS-4 & Neutrik Connectors

Custom Canare GS-4 RCA to 1/4" TS Mono Audio Cable

Connect an RCA audio connection to a 1/4" TS connection with a cable built to fit your setup. Made to order by Performance Audio using Canare GS-4 instrument cable and genuine Neutrik connectors, this single-channel assembly keeps your cable run tailored to the distance between your equipment.

One Cable, One Unbalanced Audio Channel

This cable carries one channel of unbalanced analog audio between compatible RCA and 1/4" TS connections. It can be used in either direction when the source output and destination input are compatible. For separate left and right stereo connections, use two cables.

Check your equipment's connection type and signal level before ordering. Matching plugs do not make every output and input compatible: this cable does not balance a signal, change its level, or provide electrical isolation. It is not a stereo TRS cable, a digital coaxial cable, or a speaker cable for connecting a power amplifier to a passive speaker.

Built Around Canare GS-4

• Canare GS-4 instrument cable: the wire used for this custom RCA-to-TS assembly.
• Genuine Neutrik connectors: RCA and 1/4" TS connections for your selected configuration.
• Black cable: a straightforward finish for studio, rack, and equipment connections.
• Custom labeling and finishing options: identify the signal path and organize your setup.
• Made to order with a lifetime warranty: a custom-built assembly backed by Performance Audio.

Plan the Run Before You Order

Measure along the actual cable route, allowing enough slack for strain relief and access to your equipment without leaving unnecessary coils. Check clearance behind recessed connections, crowded patch panels, and nearby controls when selecting connector configurations. Keep unbalanced runs practical for your setup and route them away from power supplies and AC cables where possible.

Connect an output to an appropriate input, not two outputs together. Once installed, check both ends for a secure fit and test the signal path at a low listening level before normal use.

Need a Different Configuration?

If you are unsure about connector fit, signal levels, cable length, or a wiring requirement, contact Performance Audio's custom cable specialists with your equipment models. We can help you plan a cable for the connection you need, including configurations you cannot build online.