Shure MXWANI4 4-Channel Audio Network Interface

PA SKU # SHU MXWANI4 MFR # MXWANI4 UPC # 042406250061
  • Support Lifetime Tech Support
  • Best Seller Best Seller!
  • Question Ask a Question
Order Now! We'll Ship It Fast! This item is currently out of stock. Most out of stock orders ship within just a few days (excluding weekends and holidays). We'll keep you up to date the whole way.
  • Product Highlights
  • For MicroFlex System
  • Dante Network Compatible
  • Per Channel Analog Outputs
  • 4-Port Gigabit Switch
  • Control with Networked Mac/PC
  • Supplies PoE
  • Headphone Output
Channels 4 8

4-Channel Audio Network Interface

Available in four- or eight-channel options, MXWANI enables easy out-of-the-box system setup with no additional networking hardware required. With a versatile 4-port gigabit switch, MXWANI connects and distributes Microflex Wireless systems to conference room AV networks. Front panel controls offer quick adjustments locally, or adjust system settings remotely from a networked PC or Mac via Microflex Wireless Control Software.
  • Ethernet connectivity sends audio and control signals over cable runs of up to 300 feet or anywhere over a corporate network
  • Power over Ethernet to the Access Point Transceiver simplifies installation
  • Corporate uplink mode allows remote control of system settings while keeping audio off the network for security and to reduce bandwidth
  • Dante networking transports digital audio received from wireless microphones over Ethernet to any other Dante-equipped device
  • Headphone output distributes solo audio signal on any channel
  • Audio
  • Frequency Response: 20 Hz to 20 kHz
  • Dynamic Range:
    Analog-to-Dante: 113 dB (20 Hz to 29 kHz, A-weighted, typical)
    Dante-to-Analog: 110 dB (20 Hz to 29 kHz, A-weighted, typical)
  • Output Noise:
    Line: -84.5 dBV (20 Hz to 29 kHz, A-weighted, typical)
    Aux: -95.2 dBV (20 Hz to 29 kHz, A-weighted, typical)
    Mic: -106.5 dBV (20 Hz to 29 kHz, A-weighted, typical)
  • THD + N: < 0.05% (20 Hz to 20 kHz@ +4dBu analog input, -10 dBFS digital input)
  • Polarity: Non-inverting, any input to any output
  • Inputs
  • Configuration: Active balanced
  • Impedance: 10.6 kΩ
  • Clipping Level:
    Line: 23.8 dBV (minimum)
    Aux: 10.8 dBV (minimum)
  • Outputs
  • Configuration: Active balanced
  • Impedance: 310 Ω
  • Clipping Level:
    Line: 26.2 dBV
    Aux: 16.2 dBV
    Mic: -3.8 dBV
  • Headphone Output: 1/4" (6.3 mm) TRS, 100 mW, 350 Ω, dual mono (will drive stereo phones)
  • DSP
  • AD/DA Conversion: 24-bit, 48 kHz
  • Latency:
    Analog-to-Dante: 0.21 ms (Estimated Nominal, +/-0.1 ms)
    Dante-to-Analog: 0.24 ms + TN (Estimated Nominal, +/-0.1 ms)
    TN = Network latency in milliseconds, as set in Dante Controller
    Note: Dante network latency is typically associated with the receiving device
  • Networking
  • Network Interface: Four-Port Gigabit Ethernet Switch, Dante digital audio
  • Uplinks: Port: Selectable, blocks multicast traffic (Port 4)
  • PoE: Provided on Port 1 to power MXWAPT
  • Cable Requirements: Cat 5e or higher, shielded, 100 m maximum between network devices
  • Network Addressing Capability: DHCP, link-local, static
  • General
  • Power Requirements: 100 to 240 V AC, 50-60 Hz, 1 A
  • Housing: Steel; Extruded aluminum
  • Temperature Range:
    Operating: 0 to 145F (-18 to 63C)
    Storage: -20 to 165F (-29 to 74C)
  • Dimensions (H x W x D): 1.7 x 19.0 x 14.4" (44 x 483 x 366 mm)
  • Weight: 6.9 lb (3.1 kg)
Write Your Own Review
You're reviewing:Shure MXWANI4 4-Channel Audio Network Interface
Your Rating