Schoeps MDZ 10 U Inline Attenuators

  • Support Lifetime Tech Support
  • Best Seller Best Seller!
  • Question Ask a Question
Order Now! We'll Ship It Fast! This item is currently out of stock. Most out of stock orders ship within just a few days (excluding weekends and holidays). We'll keep you up to date the whole way.
  • 10 sB Inline Attenuator Barrel for Phantom Powered Microphones

10 sB Inline Attenuator Barrel for Phantom Powered Microphones

In situations where microphone inputs are overloaded, we recommend inserting the MDZ 10 or MDZ 20 into the signal path between the microphone cable and the microphone input. The advantage of this setup over attenuators direcly attached to the microphone is that parasitic interference signals induced into the microphone cable are also attenuated along with the microphone signal. (Never place an in-line attenuator at the microphone end of a cable. Doing so would increase the relative strength of any induced interference, and increase the rate of signal loss in longer cables due to the higher source impedance.)

The MDZ can also prevent the input impedance of a preamp from loading down a microphone; with it in place, the minimum load impedance for a CMC-series amplifier is reduced from 600 to 200 Ohms. It can also be useful when driving transformer-equipped inputs designed for 200 Ohm sources, which may develop high frequency response errors when driven by much lower impedances, particularly if the input transformer has a high turns ratio.
  • for phantom- or parallel-powered microphones
  • ca. 10 dB / 20 dB constant attenuation
  • avoids overloading sensitive inputs
  • does not reduce the microphone's signal-to-noise ratio
  • Connector: XLR-3F / XLR-3M
  • Length: 75 mm
  • Diameter: 19 mm
  • Surface finish: black
Write Your Own Review
You're reviewing:Schoeps MDZ 10 U Inline Attenuators
Your Rating