The Avalon VT-737SP features a combination of TUBE preamplifiers, opto-
compressor, sweep
equalizer, output
level and VU metering in a
2U space.
PREAMPLIFIER
The VT-737SP has three input selections: 1. The VT-737SP features a higher-performance
microphone input transformer with +
48v phantom selection. 2. Instrument
DI high source input with
jack located on front panel. 3.
Balanced line input, discrete high-
level Class A. The
Class A preamplifier utilizes two cascaded, dual
vacuum tube triodes configured with minimum negative
feedback. A high
gain switch boosts the overall
gain of the
preamplifier. The four high quality tubes are configured as singled ended anode coupled followers. A passive-variable
high pass filter and hard-wire relay bypass completes the input signal conditioning. The
phase reverse relay is available on all three inputs.
OPTO-COMPRESSOR
The opto-
compressor features a minimum signal path design with twin
Class A vacuum tube triodes for
gain matching. The optical
attenuator acts as a simple passive
level controller. Full
dynamic control from soft
compression to hard-
knee limiting can be achieved with
threshold, ratio-
compression, attack and release controls plus
gain reduction selection on the large
VU meter. Special spectral control including de-ess is available with the dual sweep mid
EQ to
side-chain switch. The
EQ section can be flipped pre or post the opto-
compressor via a front panel switch for alternate effects and tone shaping. Two VT-737SPs can be linked via a rear panel link cable for
stereo tracking. The
compressor bypass is a sealed silver relay for the most direct signal path.
SWEEP-EQUALIZER AND OUTPUT LEVEL
The VT-737SP
equalizer utilizes 100% discrete, Class A-high-
voltage transistors for optimum sonic performance. The high and low
frequency bands provide the smooth characteristics of an all passive design, while the dual mid bands include variable
frequency and switched Q-width selection. The enhanced range of the mid bands is extended into the high and low bands by the use of X10
frequency multipliers. The bypass switch incorporates a sealed silver relay for the most direct signal path. When the
EQ to
sidechain is engaged, the high-low
EQ remains in the
audio path for "tone enhancement". The output
level control provides a variable control of the overall signal path. The output
amplifier utilizes another dual triode
vacuum tube driving a 100% discrete,
Class A, high-current,
balanced and
DC coupled low
noise output
amplifier.
AVALON VT-737SP FEATURES
Vacuum tube triode signal path, transformer
balanced microphone input, high-
voltage circuits for maximum
headroom to +30dB, low
noise -92dB, internal discrete power supply with
toroidal transformer, soft-start tube life extender,
stereo link for compressors, all discrete
Class A equalizer with musical passive
filter design, sealed silver relays for signal routing, large control knobs with professional conductive plastic potentiometers,
VU meter for output
level monitoring and
compressor gain reduction.
Specifications:
- Circuit topology: Four dual triode vacuum tubes (Sovtek 6922), high-voltage discrete Class A
- Gain Range: Microphone: Transformer balanced 850/2500 ohm, 0dB to +58dB Instrument: Unbalanced 1 meg ohm, 0dB to+30dB Line: Balanced Class A 20k ohms, -27dB to 28dB
- Maximum input level and connector types: Microphone26dB@25Hz, +30dB@1kHz balanced XLR Instrument+30dB unbalanced front panel jack socket: Line +36dB balanced XLR
- Maximum output level: +30dB balanced 600 ohms, DC coupled, discrete Class A
- Output type and gain: XLR connector, output trim gain -45dB to20dB
- Noise 20kHz unweighted: -92dB
- Noise microphone EIN: -116dB, 22Hz to 22kHz unweighted
- Distortion THD, IMD: 0.5%
- Frequency response -/2.5dB: 10Hz to 120kHz input filter included
- Frequency response -3dB: 1Hz to 200kHz line in-out
- VU meter and gain reduction: High quality illuminated OVU =+4dB and gain reduction to -20dB
- High cut filter: Variable 6dB per octave 30Hz to 140Hz
- Compressor type: Optical passive attenuator incorporating twin vacuum tubes and stereo link
- Threshold - Ratio: Threshold variable -30dB to +20dB, ratio-compression variable 1:1 to 20:1
- Attack - Release: Attack variable 2mS to 200mS, release variable 100mS to 5 seconds
- Equalizer type: Discrete Class A, variable active and switched passive design
- Frequency bands (4): Treble - switched 10kHz, 15kHz, 20kHz, 32kHz, +/- 20dB range, shelf High mid - variable 200Hz to 2k8Hz and 2kHz to 28kHz, +/- 16dB range, hi-lo Q Low mid - variable 30Hz to 450Hz and 300Hz to 4k5Hz, +/- 16dB range, hi-lo Q Bass - switched 15Hz, 30Hz, 60Hz, 150Hz, +/- 24dB range, shelf
- AC power: Internal toroidal 100v to 240v, 50-60Hz selectable, 75 watts maximum
- Dimensions: 19 x 12 x 3.5 in (482 x 305 x 89mm)
- Weight: 22lbs (10kg)
- Dimensions-shipping carton: 21 x 18 x 8 in (533 x 457 x 203mm)
- Weight-packed: 26lbs (11.8kg)